NUMERICAL MODELING OF TWO-PHASE CONDENSING FLOW OF STEAM

Authors

  • Mohd. Zamri Yusoff Departmentof Mechanical Engineering College of Engineering Universiti Tenaga Nasional (UNITEN) KIn. 7, Jalan Kajang-Puchong, 43009, Kajang, Selangor,MALAYSIA

Keywords:

Keywords

Abstract

This paper describes a" numerical model capable of predicting high speed homogeneous
condensation process of steam. The solution of the two-dimens ional fluid dynamics equations
are based on the cell-vertex finite-volume time-marching method. The spat ial integration is done using centra l discret ization and the tempora l integrat ion is done using the fourth order accurate, 4 stage Runge Kutta time integration. The governing equations are coupled with the nucleation and droplet growth equations in order to describe the high-speed condensation process. The predicted results are compared with published experimental data, which showed very good agreements.

References

Oswatitsch, K.L., 1942, 'Condensation Phenomena in Supersonic Nozzles', Z. Angew. Math. Mech., 22 (1) : 1-14 (RTP Translation No. 1905).

Yellot, J.r. , 1934, 'Supersaturated Steam ', Trans. ASME, 56: 411-430.

Binnie, A.M. and Woods, M.W., 1938, 'The Pressure Distribution in a Convergent-Divergent Steam Nozzle', Proc . lnst. Mech. Engrs., 138: 229-266

Gyannathy, G., 1962, 'Grundlagen einer Theorie der Nassdampfturbine', Diss ertation ETH, Zurich, Juris -Verlag .(English Translation: CEGB (London) Rept. T-781, 1963).

Pouring, A.A., 1965, 'Thermal Choking and Condensation in Nozzles' Phys. Fluids, 8 (10): 1802-1810 .

Barschdorff, D., 1967, 'Kurzzeitfeuchtemessung und ihre Anwendung bei Kondensationserscheinungen in Lavaldiisen', Diss. Techn. Hochschule Karlsruhe

Campbell, B.A. and Bakhtar, F., 1970, 'Condensation Phenomena in High Speed Flow ofSteam', Proc . Inst. Mech. Engrs., 185: 395-404.

Bakhtar, F. and Tochai, M.T.M. , 1980, 'An Investigation of Two-Dimensional Flows of Nucleating and Wet Steam by the Time-Marching Method', Int. J. Heat & Fluid Flow, 2 (1): 5-18

Alubaidy, A.K., 1982, 'On the Supersonic Blade to Blade Two Phase Flow of Steam', Ph.D. Thesis, University of Birmingham.

So, K.S., 1984, 'A Study ofSupersonic Blade to Blade Wet Steam Flow by the Time Marching Method', Ph.D. Thesi s, University of Birmingham.

Abbas, K., 1987, 'An Investigation of Viscous 2-D, 2-Phase Flows in Cascades of Steam Turbine Blading by the Time Marching Method', Ph.D. Thesis, University of Birmingham

Mahpeykar, M.R., 1991, 'On the Theoretical Treatment of Two-dimensional Flows of Steam and Comparison with Measurements', Ph.D Thesis, University of Birmingham.

Henson, R.J.K, 1995, 'The Theoretical Investigation of the Flow of Wet Steam in a Cascade ojRotor Tip Section Blading', Ph.D Thesis, University of Birmingham.

Zamri, M.Y., 1997, 'An Improved Treatment of Two-Dimensional Two- Phase Flows of Steam by a Runge-Kutta Method ', Ph.D. Thesis, The University of Birmingham

Denton, J.D., 1983, 'An Improved Time Marching Method Turbomachinery Flow Calculation' ASME Paper 82-GT-239.

Krol, T., 1971, 'Results of Optical Measurements of Diameters of Drops Formed Due to Condensation ofSteam in a Laval Nozzle', Trans. lnst. Fluid Flow Mach (Poland), 57: 19-30

Skillings, S.A., 1987, 'An Analysis ofthe Condensation Phenomena Occuring in Wet Steam Turbines ', Ph.D. Thesis, University of Birmingham.

Downloads

Published

2018-05-14

How to Cite

Yusoff, M. Z. (2018). NUMERICAL MODELING OF TWO-PHASE CONDENSING FLOW OF STEAM. Jurnal Mekanikal, 11(1). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/266

Issue

Section

Mechanical