PREDICTION OF THE FLOW INSIDE A MICRO GAS TURBINE COMBUSTOR

Authors

  • Yehia A. Eldrainy Department of Aeronautical Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 Johor Bahru, Johor, Malaysia
  • Johann Jeffrie Muhamad Ridzwan Department of Aeronautical Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 Johor Bahru, Johor, Malaysia
  • Mohammad Nazri Mohd Jaafar Department of Aeronautical Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 Johor Bahru, Johor, Malaysia

Keywords:

Gas turbine combustor, turbulence, combustor aerodynamics, CFD, numerical simulation

Abstract

The main purpose of this study is to predict the flow dynamics inside a micro gas turbine combustor model. The flow field inside the combustor is controlled by the liner shape and size, wall side holes shape, size and arrangement (primary, secondary and dilution holes), and primary air swirler configuration. Air swirler adds sufficient swirling to the inlet flow to generate central recirculation region (CRZ) which is necessary for flame stability and fuel air mixing enhancement. Therefore designing an appropriate air swirler is a challenge to produce stable, efficient and low emission combustion with low pressure losses. Four axial flat vane swirlers with 20°, 30°, 45° and 60° vane angle corresponding to swirl number of 0.27, 0.42, 0.74, and 1.285 respectively were used in this analysis to show vane angle effect on the internal flow field. The flow behavior was investigated numerically using CFD solver FLUENT 6.2. This study has provided physical insight into the flow pattern inside the combustion chamber. Results show that the swirling action is augmented with the increase in the vane angle, which leads to increase in the turbulence strength, recirculation zone size, and amount of recirculated mass. However, all these happen at the expense of the increase in pressure losses. In case of 20° swirler (swirl number < 0.4), the produced swirling flow is not enough to generate CRZ.

References

Pilavachi, P.A., 2002. Mini and micro-gas turbines for combined heat and power, Applied Thermal Engineering, 22, No. 18, 2003-2014.

Fuligno, L., Micheli, D. and Poloni, C., 2006. An Integrated Design Approach for Micro Gas Turbine Combustors: Preliminary 0-D and Simplified CFD Based Optimization, ASME Turbo Expo, Spain.

Cameretti, M. and Tuccillo, R., 2004. Comparing Different Solutions for the Micro-Gas Turbine Combustor, ASME Turbo Expo, Austria.

Lefebvre, A., 1983. Gas Turbine Combustion, McGraw-Hill, USA.

Collin, R. and Ward, J., 1990. Industrial Furnace Technology, Short Course, Jld. I and II. Porto: Cenertec, Centro De Energia E Technologia, Portugal.

Beer, J.M. and Chigier, N.A, 1972. Combustion Aerodynamics, Applied Science Publishers, London.

Thring, M.W. et al., 1971. The Aerodynamics of Annular Jet Registers, Paper presented at 2nd Members Conference, IFRF, Ijmuiden, Holland.

Mellor, A.M., 1990. Design of Modern Gas Turbine Combustors, Academic Press.

Drake, P.F. and Hubard, E.H., 1963. Effect of air swirl on the completeness of combustion, J. Inst. Fuel, 36:389.

Claypole, T.C. and Syred, N., 1981. The Effect of Swirl Burner

Aerodynamics on NOx Formation, Eighteenth International Symposium on Combustion, 8, 81-89.

Mestre, A., 1974. Efficiency and Pollutant Formation Studies in a Swirling Flow Combustor, Fluid Mechanics of Combustion, Edited by Dussord et al., ASME, New York.

Chigier, N.A., 1987. Progress in Energy and Combustion Science, 4, Oxford, Pergamon Press, UK.

Yakhot, A. and Orszag, S., 1986. Renormalisation Group Analysis of Turbulence: I, Basic Theory, Journal of Scientific Computing, 1, No. 1, 3-51.

FLUENT 6.2 User's Guide, Fluent Inc. 2005.

Downloads

Published

2018-04-09

How to Cite

Eldrainy, Y. A., Muhamad Ridzwan, J. J., & Mohd Jaafar, M. N. (2018). PREDICTION OF THE FLOW INSIDE A MICRO GAS TURBINE COMBUSTOR. Jurnal Mekanikal, 25(1). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/153

Issue

Section

Mechanical

Similar Articles

<< < 11 12 13 14 15 16 

You may also start an advanced similarity search for this article.