RESIDUAL STRESSES AROUND COLD WORKED HOLES IN 2024-T3SI ALUMINIUM ALLOY PLATE SPECIMEN

Authors

  • P R Arora P R Arora Department of Aerospace Engineering Faculty of Engineering University Putra Malaysia 43400 UPM Serdang, Selangor
  • Abdalla A i Ab Rashd Department of Aerospace Engineering Faculty of Engineering University Putra Malaysia 43400 UPM Serdang, Selangor
  • A.M. S. Hamouda A.M. S. Hamouda Department of Aerospace Engineering Faculty of Engineering University Putra Malaysia 43400 UPM Serdang, Selangor

Keywords:

Keywords

Abstract

A finite element simulation study is carried for cold working process ON 2024·T351 aluminum
alloys plate. During the process the load is transferred by A mandrel to the plate. which tries to
bend a portion of the plate and affects the formation of residual stresses resulting from the cold
working process. It is observed that non-dimensional radial residual stress for entrance face and mid thickness plane at the edge of the hole is affected a little by the start of support distance i.e. for various support conditions. Whereas, the tensile radial residual stress for the exit face reduces considerably from a value of 1.05 to approximately zero , The non-dimensional tangentlal residual stresses for the entrance decrease with start of support distance. Whereas, the non-dimensional tangential residual stresses for the mid plane and exit face reduce from higher compressive stress to tower compressive stress.

Downloads

Published

2018-05-14

How to Cite

P R Arora, P. R. A., Ab Rashd, A. A. i, & A.M. S. Hamouda, A. S. H. (2018). RESIDUAL STRESSES AROUND COLD WORKED HOLES IN 2024-T3SI ALUMINIUM ALLOY PLATE SPECIMEN. Jurnal Mekanikal, 12(2). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/254

Issue

Section

Mechanical

Similar Articles

1 2 3 4 5 6 7 > >> 

You may also start an advanced similarity search for this article.