EFFECT OF OIL PALM SHELL CARBON-POLYESTER RESIN COMPOSITE ON MICROWAVE ABSORBER PROPERTIES

Authors

  • Farid Nasir Ani Fakulti Kejuruteraan Mekanikal Universiti Teknologi Malaysia 81310 Johor Bahru, Johor Malaysia
  • Wan Khairuddin Wan Ali Fakulti Kejuruteraan Mekanikal Universiti Teknologi Malaysia 81310 Johor Bahru, Johor Malaysia
  • Ahmad Anas Yusof Faculty of Mechanical Engineering, Kolej Universiti Teknikal Kebangsaan Malaysia. Locked Bag 1200, Ayer Keroh, 75450 Melaka, Malaysia

Keywords:

Composite, Microwave Absorber, Dielectric Properties, Waste Utilization

Abstract

Pyrolysis effect on the dielectric properties of microwave absorber composed of palm shell
carbon-polyester resin composite was studied. The permittivity, E, and loss tangent, tan is
of the composite were studied in the 8 to 12 GHz frequency range which emphasize the
influence of carbon 'concentration (mass %) of pyrolysed oil palm shell carbon at 600°C,
700°C and 800°C. It was'observed that the increase of carbon concentration inside each
measured composite influenced the increase of E: and tan is condition. This indicates the
possibility of using carbon derived from oil palm shell residue in providing significant loss
in contributing to microwave absorption, as well as an alternative in managing the
increase of oil palm shell residues throughout the country.

References

Ma A.N., Toh T.S. and Chua N.S., (1999), " Renewable Energy from Oil Palm Industry " in Oil Palm and The Environment - A Malaysian Perspective (edited by Gurmit S.), Malaysian Oil Palm Growers' Council, Kuala Lumpur, pp 253-259.

Rahim and Khozirah, (1991), "Effect of Wood/ Gypsum Ratio and Density on Strength Properties of Gypsum Bonded Particleboard from Oil Palm Stems." Journal of Tropical Science, Vol. 4, No.1, pp 80-86.

Kamarudin H, Ariffin D, Jalani S, and Mohd Nor M.Y., (1999), "Pulp and Paper from Oil Palm Biomass", in "Oil Palm and The Environment - A Malaysian Perspective" (edited by Gurmit S.), Malaysian Oil Palm Growers' Council, Kuala Lumpur, pp 213-225.

Mohamad Husin, Ridzuan Ramli, Anis Mokhtar and Azlimar Abdul Aziz, (2002), "Research and Development of Oil Palm Biomass Utilization in Wood-based Industries ", Palm Oil Development No 36, Malaysian Palm Oil Board, pp 1-5.

Islam, M.N., Ani, F.N. and Ramlan Z, (1999), "Pyrolytic Oil from Fluidised Bed Pyrolysis of Oil Palm Shell and its Characterisation", Renewable Energy, Vol. 17, pp 73-84.

Asiah Hussain, (1993), "Kesan Teknik penyediaan Karbon Teraktif daripada Tempurung Kelapa Sawit Terhadap Keliangan dan Keupayaan Penjerapan", Jurnal Teknologi.. VTM. Vol 22, pp 51-70.

Kaynak, A., Plat, A, and Yilmazer, V., (1996), "Some Microwave and Mechanical Properties of Carbon Fiber Polypropylene and Carbon-Black Polypropylene Composites", Material Research Bulletin, Vol 31, No 10, pp 1195-1206.

Yamamoto Ken, Matsuura, T., Mondo, M. and Tsukawali, S., (2001), "Development of Electromagnetic Wave Absorber Composed of Charcoal Powder and Unsaturated Polyester Resin," Technical Report, Tobu Industrial Research Centre, Japan.

Naidasham, K., and Kadaba, P.K., (1991), "Measurement of the Microwave Conductivity ofa Polymeric Material with Potential Application in Absorbers and Shielding", IEEE Transaction on Microwave Theory and Techniques. Vol. 39, No 7.

Raghavendra, S.C., Iqbal Ahmed Khan, Hadalgi P.M. and Kulkarni A.B., "Microwave Reflection and Radiation Properties of Polyester-Fly Ash Composites", Abstract.

Jachym, (1982), "Conduction in Carbon Black-Doped Polymers. " in Carbon Black - Polymer Composites: The Physics of Electrically Conducting Composites " (edited by Sichel E.K.), Marcel Dekker Incorporated, New York, pp 103-132.

Neelakanta, P.S. and Park, J.C, (1995), "Microwave Absorption by Conductor loaded Dielectric", IEEE Trans on Microwave Theory and Technique, Vol. 43, No 6, pp 1381-1383.

Srivastana, G.P., Singh, P.P. and Nath, J., (1992), "Microwave Absorber Composed of Rubber, Carbon and Ferrite", Asia Pacific Microwave Conference, Adelaide, pp 239-242.

Chambers, B., (1995), "Symmetrical Radar Absorbing Structures", Electronics Letters,Vo131, No 5, pp 404-405.

Kumar, (1987), "Acetalyne Black: A Single Layer Microwave Absorber", Electronic Letters. Vol 23, No 5, pp 184-185.

McCauley, J.W., Halpin, Jr., B.M., Hynes, T. and Eitelman, S.D., (1980), "Radar Absorptive Ferrite/Resin Composites from Industrial Effluent," Ceramic Engineering and Science Procurement, Vol 1, pp 356-369.

Pitman, K.C., Lindley, M.W., Simkin, D. and Cooper, J.F., (1991), "Radar Absorbers: Better by design". IEEE Proceedings-F, Vol 138, No 3, pp 223228.

Knott, E.F., Shaeffer, J.F. and Tulley, M.T., (1993), "Radar Cross-Section", 2nd Ed., Artech House, London.

Downloads

Published

2018-04-24

How to Cite

Ani, F. N., Wan Ali, W. K., & Yusof, A. A. (2018). EFFECT OF OIL PALM SHELL CARBON-POLYESTER RESIN COMPOSITE ON MICROWAVE ABSORBER PROPERTIES. Jurnal Mekanikal, 19(1). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/196

Issue

Section

Mechanical

Similar Articles

1 2 3 4 5 6 7 8 9 > >> 

You may also start an advanced similarity search for this article.