IMPROVING PROCESS QUALITY IN FRICTION WELDING FOR BIMETAL LUGS

Authors

  • Noni Rosyani Rosli Department of Materials, Manufacturing and Industrial Engineering Faculty of Mechanical Engineering Universiti Teknologi Malaysia 81310 UTM, Johor Bahru Malaysia
  • Adnan Hassan Department of Materials, Manufacturing and Industrial Engineering Faculty of Mechanical Engineering Universiti Teknologi Malaysia 81310 UTM, Johor Bahru

Keywords:

Friction Welding, Bimetal Lugs, Design of Experiment, Full Factorial

Abstract

The purpose of this study is to investigate the effect of process parameter settings on quality of bimetal lugs produced by friction welding process. The study was conducted in a local electrical power components manufacturer. The company faced high reject rates of bimetal lugs. To avoid disturbance to the actual production line, the relevant historical process data were extracted and analysed. The data were mapped into full factorial experimental design matrix. The significance of operating parameters, namely, the rotational speed, friction pressure and friction time were investigated. The data analysis reveals the recommended optimum setting should be; rotational speed at high level (1450 Rpm), friction pressure at low level (39.2 Pa) and friction time at low level (4 s). The first order models are also proposed for prediction of the responses; tensile strength, upset and temperature.

References

Vill, V.I., 1962. Friction Welding of Metals. American Welding Society.

Montgometry, D.C., 2005. Design and Analysis of Experiments (6th edition). United States of America. : John Wiley & Sons, inc.

Fryman, M.A., 2002. Quality and Process Improvement (1st edition), United States of America. Delmar Thomson Learning.

Muhammad Fadlee bin Abu Bakar, 2012. Characterization of Operating Conditions for Ball Bearings Through Design of Experiment. Universiti Teknologi Malaysia: B. Eng. Report.

Mohamad Faizal Bin Anuar, 2008. Process Optimization of Vacuum Forming Process by Using Design of Experiment. Universiti Teknologi Malaysia: B. Eng. Report.

Sekharan Gopal, 2003. Optimization on solder paste printing parameters. Universiti Teknologi Malaysia: B. Eng. Report.

Downloads

Published

2018-04-01

How to Cite

Rosli, N. R., & Hassan, A. (2018). IMPROVING PROCESS QUALITY IN FRICTION WELDING FOR BIMETAL LUGS. Jurnal Mekanikal, 38(1). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/26

Issue

Section

Mechanical

Similar Articles

1 2 3 4 5 6 7 8 9 10 > >> 

You may also start an advanced similarity search for this article.