Wind Tunnel Testing of Ice Roughness Effect on UTM Half Model

Authors

  • Tengku Mohamed T.A.A.H. School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor
  • Mohd Zawawi F. School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor
  • Mat S. School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor

Keywords:

Ice roughness, swept wing, UTM half model, aerodynamic performance

Abstract

Ice accretion effect on the aircraft is a great threat to flight safety. The impact on flight performance is detrimental that it could lead to catastrophic event. This research was carried out to investigate the effect of ice roughness on a three-dimensional (3D) swept wing of the Universiti Teknologi Malaysia (UTM) half model (aircraft) by using a wind tunnel facility. The ice roughness model with different heights was replicated on the leading-edge of the half model swept wing. The test was conducted at the UTM Aerolab Low Speed Tunnel considering low Reynolds number. The UTM half model was configured at three different flap angles to simulate the flight phase of take-off, cruise and landing. The results from the semi-span component balance were analysed and compared with the clean model as baseline. The aerodynamic performance penalty was observed to be substantial. The performance loss was more severed with higher ice roughness height and the finding is in agreement with the published literature for wind tunnel testing of a 3D swept wing.

References

Comair Flight 3272, Retrieved from: https://en.wikipedia.org/wiki/Comair_Flight_3272. [Accessed: 1 September 2019].

Olsen W. and Walker E., 1983. Close up Motion Pictures of the Icing Process, NASA LeRC Film.

Olsen W. and Walker E., 1986. Experimental Evidence for Modifying the Current Physical Model for Ice Accretion on Aircraft Structures, NASA TM 87184.

Beard M., 1982.Hazards Following Ground Deicing and Ground Operations in Conditions Conducive to Aircraft Icing, AC 20-117, Washington, DC: FAA.

Shin J., 1996. Characteristics of Surface Roughness Associated with Leading-edge Ice Accretion,Journal of Aircraft, 33(2):316-321.

Broeren A.P., Bragg M.B., Addy H.E., Lee S., Moens F. and Guffond D., 2010. Effect of High-fidelity Ice-accretion Simulations on Full-scale Airfoil Performance, Journal of Aircraft, 47(1):240-254.

Bragg M.B., Broeren A.P. and Blumenthal L.A., 2005. Iced-airfoil Aerodynamics,Progress in Aerospace Sciences, 41(5):323-362.

Hu T., Lv H., Tian B. and Su D., 2014. Choosing Critical Ice Shapes on Airfoil Surface for the Icing Certification of Aircraft, Procedia Engineering, 80:456-466.

Diebold J., Monastero M. and Bragg M., 2012. Aerodynamics of a Swept Wing with Ice Accretion at Low Reynolds Number, 30thAIAA Applied Aerodynamics Conference 2012.

Ujang M.I., 2016. Experimental Study of Half Model Transport Aircraft at Several Flap and Control Surfaces Configuration. BEng Thesis, Universiti Teknologi Malaysia, Skudai.

Rhubbindran A/L Sunthrasakaran, 2014. Flow Separation Measurement above UTM Half Model, BEng Thesis, Universiti Teknologi Malaysia, Skudai.

Neely R.H. and Conner D.W., 1947. Aerodynamic Characteristics of a 42 deg SweptBack Wing with Aspect Ratio 4 and NACA 64-112 Airfoil Sections at Reynolds Numbers from 1.700, 000 to 9,500,000, National Advisory Committee for Aeronautics Langley Field VA Langley Aeronautical Laboratory.

Sivells J.C. and Spooner S.H., 1947. Investigation in the Langley 19-foot Pressure Tunnel of Two Wings of NACA 65-210 and 64-210 Airfoil Sections with Various Type Flaps.NACA Technical Reports, Report 942: 419-441.

Downloads

Published

2019-12-31

How to Cite

T.A.A.H., T. M., F., M. Z., & S., M. (2019). Wind Tunnel Testing of Ice Roughness Effect on UTM Half Model. Jurnal Mekanikal, 42(2). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/390

Issue

Section

Mechanical

Similar Articles

<< < 8 9 10 11 12 13 14 15 16 17 > >> 

You may also start an advanced similarity search for this article.