TRIBOLOGICAL FEATURES OF REFINED, BLEACHED AND DEODOURISED (RBD) PALM OLEIN BLENDS WITH MINERAL OIL

Authors

  • Mohammed Hassan Jabal Electromechanical Engineering, University of Technology, Iraq
  • Farid Nasir Ani Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru MALAYSIA
  • S. Syahrullail S. Syahrullail Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru MALAYSIA

Keywords:

Refined, bleached and deodorized palm olein, blending ratio, wear scar diameter, coefficient of friction

Abstract

Vegetable oil has been investigated to replace petroleum-based products due to its environment-friendly characteristics and has become a vital source of bio-lubricants. The usefulness of vegetable oil is its availability as one of the renewable sources. Additionally, the vegetable oils based lubricant has indicated the potentials for reducing carbon dioxide and hydrocarbon emission while operating in internal combustion engines and in industrial process. There are two ways for using vegetable oils as bio-lubricants, either by directly using the neat vegetable oils without blending or using certain blending ratio of the vegetable oils along with the commercial lubricants. In this paper, the influences of the blending ratio of mineral oil with one type of vegetable oil was investigated on the tribological characteristics and compared with commercial lubricant oil using the four ball tribotester. Refined, bleached and deodorized (RBD) palm olein was blended at volumetric ratio ranging from 20 to 80 % with commercial mineral oil. All experimental works were conforming to ASTM D4172. The results exhibit that some blends of RBD palm olein with commercial lubricant oil have lower the wear scar diameter compared to mineral oil. Blends exhibit lower the wear scar diameter and coefficient of friction compared to commercial lubricant oil. As conclusion, the blends of RBD palm olein with commercial lubricant oil has better tribological performance compared to commercial mineral oil or neat RBD palm olein.

References

Delgado, M.A., Quinchia, L.A., and Galegos, C., 2010. Viscosity modification of different vegetable oil with EVA copolymer for lubricant applicants, Industrial Crops and Products, 32, 607-612.

Golshokouh, I., Syahrullail, S., Shariatmadari, S., and Ani, F.N., 2014. Investigate Jatropha oil as new source of lubricant oil, Advanced Materials Research, 1043, 219-223.

Kalin, M. and Vizintin, J., 2006. A comparison of the tribology behaviour of steel/steel, steel/DLC and DLC/DLC contacts when lubricated with mineral and biodegradable oil, Wear, 261, 22-31.

Golshokouh I., Syahrullail, S., Ani, F. N., and Masjuki, H.H., 2014. Investigation of Palm Fatty Acid Distillate Oil as an Alternative to Petrochemical Based lubricant, Journal of Oil Palm Research, MPOB, 26, 25-36.

Bari, S., Lim, T.H., and Yu, C.W., 2002. Effect of preheating of crude palm oil (CPO) on injection system, performance and emission of a diesel engine, Renewable Energy, 27, 339-351.

Wan Nik, W.B., Ani, F.N., and Masjuki, H.H., 2005. Thermal stability evaluation of palm oil as energy transport media, Energy Conversion and Management, 46 (13), 2198-2215.

Wan Nik, W.B., Maleque, M.A., Ani, F.N., and Masjuki, H.H., 2007. Experimental investigation on system performance using palm oil as hydraulic fluid, Industrial Lubrication and Tribology, Emerald Publication. 59(5), 200-208.

Syahrullail, S., Nakanishi, K., and Kamitani, S., 2005. Investigation of the effects of frictional constraint with application of palm olein oil lubricant and paraffin mineral oil lubricant on plastic deformation by plane strain extrusion, Journal of Japanese

Society of Tribologists, 50(12), 877-885.

Syahrullail, S., Zubil, B.M., Azwadi, C.S.N., and Ridzuan, M.J.M. (2011) Experimental evaluation of palm oil as lubricant in cold forward extrusion, International Journal of Mechanical Sciences, 53, 549–555.

Ing, C.T., Mohammed Rafiq, A.K., Azli, Y., and Syahrullail, S., 2012. The effect of temperature on the tribological behavior of RBD palm stearin, Tribology Transactions, 55(5), 539–548.

Maleque, M.A. and Masjuki, H.H., 1997. Investigation of the anti-wear characteristics of palm oil methyl ester using a four-ball tribometer test, Wear, 206, 179–186.

Nor Hayati, I., Yaakob, B.C.M., Chin, P.T., and Idris, N.A., 2009. Thermal behavior

of concentrated oil-in-water emulsions based on soybean oil and palm kernel olein blends, Food Research International, 42, 1223–1232.

Jabal M.H., Ani, F.N., and Syahrullail, S., 2014. The Tribological Characteristic of the Blends of RBD Palm Olein with Mineral Oil using Four-ball Tribotester, Jurnal Teknologi, 69(6), 11-14.

Maleque, M.A., Masjuki, H.H., and Haseeb, A.S.M.A., 2000. Effect of mechanical factors on tribological properties of palm oil methyl ester blended lubricant, Wear, 239 ,117–125.

Boerlage G, 1933. Four-ball testing apparatus for extreme pressure lubricants, Engineering, 136, 46-47.

Golshokouh, I., Golshokouh, M., Ani, F. N., Kianpour, E., and Syahrullail, S., 2013. Investigation of the physical properties for jatropha oil in different temperature as lubricant oil, Life Science Journal, 10, 110-119.

Masjuki, H.H. and Maleque, M.A., 1997. Investigation of the anti-wear characteristics of palm oil methyl ester (POME) contaminated with lube oil using a Four-ball machine of IP239 standard, Wear, 206, 179-186.

Downloads

Published

2018-04-01

How to Cite

Jabal, M. H., Ani, F. N., & S. Syahrullail, S. S. (2018). TRIBOLOGICAL FEATURES OF REFINED, BLEACHED AND DEODOURISED (RBD) PALM OLEIN BLENDS WITH MINERAL OIL. Jurnal Mekanikal, 38(2). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/21

Issue

Section

Mechanical

Similar Articles

1 2 3 4 5 6 7 8 9 10 > >> 

You may also start an advanced similarity search for this article.