PREDICTING THE BACK SURFACE TEMPERATURE OF PHOTOVOLTAIC MODULES IN HOT AND HUMID CLIMATES

Authors

  • Mohd Afzanizam Mohd Rosli Faculty of Mechanical Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76540 Durian Tunggal, Melaka
  • Sohif Mat Solar Energy Research Institute, Universiti Kebangsaan Malaysia 43600 Bangi, Selangor
  • Kamaruzzaman Sopian Solar Energy Research Institute, Universiti Kebangsaan Malaysia 43600 Bangi, Selangor
  • Mohd Khairul Anuar Sharif Faculty of Mechanical Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76540 Durian Tunggal, Melaka
  • Mohd Yusof Sulaiman Faculty of Mechanical Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76540 Durian Tunggal, Melaka
  • Elias @ Ilias Salleh Solar Energy Research Institute, Universiti Kebangsaan Malaysia 43600 Bangi, Selangor
  • Lim Chin Haw Faculty of Mechanical Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76540 Durian Tunggal, Melaka

Keywords:

Photovoltaic, thermal modelling, back surface, hot and humid climate

Abstract

In this study, the temperature of the back surface of a photovoltaic (PV) module was calculated based on thermal energy balance. A 1D analysis was also conducted. Each layer was modeled in consideration of the effect of heat transfer modes, such as conduction, radiation, and convection. The temperature value of each layer is important for estimating of the efficiency the module or other PV applications. The PV thermal (PVT) is an innovative design that utilizes PV, and back surface temperature is applicable in the detailed analysis of each PVT collector layer. A few assumptions were made to simplify the analysis. Experimental and thermal modeling results are satisfactory, and irradiance does not fluctuate suddenly. The correlation coefficient (r) and the percent deviation in root mean square (e) are 0.931 and 12.1%, respectively. When irradiance fluctuates suddenly, r and e are 0.345 and 58.5%, respectively.

References

J. K. Tonui and Y. Tripanagnostopoulos., 2007. Improved PV/T solar collectors with heat extraction by forced or natural air circulation, Renewable Energy 32, 623–637.

B. Huang, T. Lin, W. Hung, and F. Sun., 2001. Performance evaluation of solar photovoltaic/thermal systems, Solar. Energy 70, 443–448.

M. Bakker, H. A. Zondag, M. J. Elswijk, K. J. Strootman, and M. J. M. Jong., 2005. Performance and costs of a roof-sized PV/thermal array combined with a ground coupled heat pump, Solar Energy 78, 331–339.

M. A. M. Rosli, S. Misha, K. Sopian, S. Mat, M. Y. Sulaiman and E. Salleh., 2014. Parametric Analysis on Heat Removal Factor for a Flat Plate Solar Collector of

Serpentine Tube, World Appllied Science Journal 29, 184–187.

P. G. Charalambous, G. G. Maidment, S. a. Kalogirou, and K. Yiakoumetti., 2007. Photovoltaic thermal (PV/T) collectors: A review, Applied Thermal Engineering 27, 275–286.

P. Dupeyrat, C. Ménézo, and S. Fortuin., 2014. Study of the thermal and electrical performances of PVT solar hot water system, Energy Building 68, 751–755.

Y. Tripanagnostopoulos, T. H. Nousia, M. Souliotis, and P. Yianoulis., 2002. Hybrid Photovoltaic / Thermal Solar Systems, Solar Energy 72, 217–234.

S. Dubey and A. A. O. Tay., 2013. Testing of two different types of photovoltaic – thermal (PVT ) modules with heat flow pattern under tropical climatic conditions, Energy Sustainable Development 17, 1–12.

L. W. Florschuetz., 1979. Extension of The Hottel-Whillier Model to the Analysis of

Combined Photovoltaic / Thermal Flat Plate Collectors, Solar Energy. 22, 361–366.

A. Tiwari and M. S. Sodha., 2006. Performance evaluation of solar PV/T system: An experimental validation, Solar Energy 80, 751–759.

S. Dubey and G. N. Tiwari., 2008. Thermal modeling of a combined system of photovoltaic thermal (PV/T) solar water heater, Solar Energy 82, 602–612.

S. C. Solanki, S. Dubey, and A. Tiwari., 2009. Indoor simulation and testing of photovoltaic thermal (PV/T) air collectors, Applied Energy 86, 2421–2428.

Downloads

Published

2018-04-01

How to Cite

Mohd Rosli, M. A., Mat, S., Sopian, K., Sharif, M. K. A., Sulaiman, M. Y., Salleh, E. @ I., & Chin Haw, L. (2018). PREDICTING THE BACK SURFACE TEMPERATURE OF PHOTOVOLTAIC MODULES IN HOT AND HUMID CLIMATES. Jurnal Mekanikal, 37(2). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/39

Issue

Section

Mechanical

Similar Articles

<< < 1 2 3 4 5 6 7 8 9 10 > >> 

You may also start an advanced similarity search for this article.