THE EFFECT OF MICRO-BUBBLES ELIMINATION PRIOR RESIN INFUSION PROCESS

Authors

  • Md Afendi M Yusuf Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 Johor Bahru, Johor

Keywords:

Micro-bubbles, voids content, resin infusion, strenght, moulding.

Abstract

The treatment of resin mixture prior to resin infusion is discussed. The elimination of micro-bubble due to entrained air during mixing process had been alone using a novel technique of captillary separation  method. In this process micro-bubbles were separated from viscous resin mixture, thus bubble-free resin was produced and then infused. Tested samples using treated resin experimentally showed less void contents snd higher tensile strenght.

Downloads

Published

2018-04-17

How to Cite

M Yusuf, M. A. (2018). THE EFFECT OF MICRO-BUBBLES ELIMINATION PRIOR RESIN INFUSION PROCESS. Jurnal Mekanikal, 24(2). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/159

Issue

Section

Mechanical

Similar Articles

1 2 3 > >> 

You may also start an advanced similarity search for this article.