THE EFFECT OF FUEL FEED RATE ON TEMPERATURE PROFILES OF A CASCADING HEARTH WITH SECONDARY SWIRL COMBUSTOR

Authors

  • Wan Ahmad Najmi Wan Mohamed Department of Fluid and Thermodynamics Faculty of Mechanical Engineering Universiti Teknologi Malaysia 81310 Johor Bahru, Johor
  • Farid Nasir Ani Department of Fluid and Thermodynamics Faculty of Mechanical Engineering Universiti Teknologi Malaysia 81310 Johor Bahru, Johor

Keywords:

Cascading hearth, swirl combustor, wlid waste, fuel feed rare, temperature distribution.

Abstract

The abundant availability of biomass solid wastes in Malaysia such as palm shells from the oil palm industry promotes diversified research fields for its utilization. This paper investigates the application of a cascading hearth staged combustor to palm shells combustion in terms of fuel feed rate effect on temperature profiles. The application of a two-step hearth setup at primary stage combustion offers wider alternatives for solid phase combustion processes. Initial combustion studies of palm shells by controlled air combustion conditions using these set-ups show promising results for further development. Controlled air conditions promote gasification of the solid fuel and significantly lower combustor temperatures below 500˚C. Varying the fuel feed at 0.1, 0.15 and 0.2 kg/min with constant air supply of 227 liters/min (8 CFM) and good fuel distribution on the hearth leads to fuel core temperatures exceeding 1000˚C. As a result of high core temperatures. release rates of volatiles and combustible gases increases which influences  attainable secondary combustion temperatures. The maximum secondary stage combustion exhaust temperature recorded was 490˚C at 0.2 kg/min fuel feed. a secondary air supply of 42.5 liters/min (1.5 CFM) and a corresponding fuel core temperature of 1225˚C.

Downloads

Published

2018-05-07

How to Cite

Wan Mohamed, W. A. N., & Ani, F. N. (2018). THE EFFECT OF FUEL FEED RATE ON TEMPERATURE PROFILES OF A CASCADING HEARTH WITH SECONDARY SWIRL COMBUSTOR. Jurnal Mekanikal, 13(1). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/250

Issue

Section

Mechanical

Similar Articles

<< < 3 4 5 6 7 8 9 10 11 12 > >> 

You may also start an advanced similarity search for this article.