KINEMATICAL SUSPENSION OPTIMIZATION USING DESIGN OF EXPERIMENT METHOD

Authors

  • Mohd Awaluddin A Rahman Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor
  • Afandi Dzakaria Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor

Keywords:

Optimization, Response Surface Method

Abstract

This paper presents optimization of two suspension quarter car model using Design of Experiment Method. The aim is to determine suspension parameters to achieve the best comfort for human. Two models are used, which are 2 degree of freedom (2 DOF) and 3 degree of freedom (3 DOF). Sprung mass acceleration and also kinematic criteria chamber angle and toe angle had been used to validate both models. The optimization results are compared using step excitation base on the conditions from literature of optimal suspension system. In the case of 2 DOF suspension model at initial condition with optimized value from the literature, sprung mass acceleration did reduce by 32.36%, but suspension working space did increase by 18.71%. Dynamic tyre load did not show significant change which reduces by 0.02%. For 3 DOF suspension model at initial condition with optimize value from the literature, sprung mass acceleration did reduce by 32.28%, but suspension working space only increase by 0.09% and dynamic tyre load reduce only by 0.05% which did not shown significant change.

References

Genta, G and Morello, L., 2009. The Automotive Chassis Volume 1, Springer, Netherlands.

Tey, J.Y., Ramli, R., Kheng, C.W., Chong, S.Y. and Abidin, M.A.Z., 2013. Identification of vehicle suspension parameters by design optimization. Engineering Optimization 46(5), 669-686.

Abbas, W., Emam, A., Abbas, S., Shebl, M. and Abouelatta, O., 2013. Optimal Seat and Suspension Design for a Half-Car with Driver Model Using Genetic Algorithm. Intelligent Control and Automation 2013 (4), 199-205.

Fallah, M. S., Xie, R., and Xie, W. F., 2009. New model and simulation of Macpherson suspension system for ride control applications. Vehicle System Dynamics 47(2), 195–220.

Kovacs, A.P., 2002. Geometric event constraints: Design synthesis by multibody Lagrangian type I formalism. Journal Vehicle Design 29, 160-177.

Bae, S., Lee, J. M., Choi, W. J., Jun, J. R., and Tak, T. O., 2003. Axiomatic approach to the kinematic design of an automotive suspension system with the McPherson strut type. Journal Vehicle Design 31, 58-71.

Downloads

Published

2018-04-01

How to Cite

A Rahman, M. A., & Dzakaria, A. (2018). KINEMATICAL SUSPENSION OPTIMIZATION USING DESIGN OF EXPERIMENT METHOD. Jurnal Mekanikal, 37(1). Retrieved from https://jurnalmekanikal.utm.my/index.php/jurnalmekanikal/article/view/43

Issue

Section

Mechanical

Similar Articles

<< < 10 11 12 13 14 15 16 17 18 19 > >> 

You may also start an advanced similarity search for this article.