ANALYSIS OF MICRO GAS TURBINE PERFORMANCE USING MODELLING APPROACH

Authors

  • Norazila Othman Universiti Teknologi Malaysia

DOI:

https://doi.org/10.11113/jm.v47.473

Keywords:

Combustion Chamber, Computational fluid dynamics, micro gas turbine, power generation, simulation performance

Abstract

Micro-gas turbine (MGT) is compact and self-sufficient distributed power generation units that exhibit reliability and has the capability to mitigate carbon monoxide (CO) emissions while conserving energy together with biomass used as a fuel sources. It is expected that they will have a noteworthy impact on securing the provision of upcoming energy resources for isolated areas, disaster condition and off-grid zone regardless of their connection to the power grid. However, the MGT performance using the various fuel still questionable. Databases and procedure of the MGT performance analysis should be established well to understand the overall MGT performance. In this study, MGT performance is determined by utilising the computer aided design (CAD) and solver software such as SOLIDWORKS and ANSYS-FLUENT. CAD drawing is used to design the combustion chamber and simulation performance is visualised in specific inside the combustion chamber (CC) of the MGT. The solver software was employed for the purpose of conducting computational fluid dynamics (CFD) analyses. The optimal configuration contained a flame holder with a diameter of 50 millimetres, a chamber height of 60 centimetres, four holes with diameters of 6, 8, and 10 millimetres, and a dead zone separating the combustion and dilution zones. The air inlet boundary conditions were established by utilising the specifications and compressor maps of the Garrett GT25 turbocharger in the simulation. The simulation employed the standard k-ε model of viscous model and energy equation to establish an optimal maximum airflow rate of 0.15 kg/s at a pressure of 1.4 bar, resulting in a compressor efficiency of approximately 70%. Three different fuels, diesel-air, wood-volatiles-air, and coal-hv-volatile, were used to determine the MGT's optimal performance. Successful investigation of this study opts to significant contribution to understand the MGT performance thus, give the awareness to choose as one of the alternative power generations which can be used in the future.

References

Al-Attab, K. A., & Zainal, Z. A. (2014). Performance of a biomass fueled two-stage micro gas turbine (MGT) system with hot air production heat recovery unit. Applied Thermal Engineering, 70(1), 61–70. https://doi.org/10.1016/j.applthermaleng.2014.04.030

Oppong, F., van der Spuy, J., Willem Von Backström, T., & Diaby, A. L. (n.d.). An overview of micro gas turbine engine performance investigation. Solar thermal treatment of manganese ores View project Infrastructure for harvesting sustainable and renewable energy View project. https://doi.org/10.13140/RG.2.2.10055.09123

Allen, C. A. W., Watts, K. C., Gunter, N., Scotia, C. ;, Chris Watts, K., & Member, A. (2000). EXPERIMENTAL METHOD FOR DERIVATION OF DATA FOR REGRESSION MODELS COMPARATIVE ANALYSIS OF THE ATOMIZATION CHARACTERISTICS OF FIFTEEN BIODIESEL FUEL TYPES.

Black, F. (n.d.). An Overview of the Technical Implications of Methanol and Ethanol as Highway Motor Vehicle Fuels International Fuels and Lubricants Meeting and Exposition Toronto, Canada

Chiaramonti, D., Rizzo, A. M., Spadi, A., Prussi, M., Riccio, G., & Martelli, F. (2013). Exhaust emissions from liquid fuel micro gas turbine fed with diesel oil, biodiesel and vegetable oil. Applied Energy, 101, 349–356. https://doi.org/10.1016/j.apenergy.2012.01.066

Enagi, I. I., Al-attab, K. A., & Zainal, Z. A. (2017). Combustion chamber design and performance for micro gas turbine application. Fuel Processing Technology, 166, 258–268. https://doi.org/10.1016/j.fuproc.2017.05.037

Laforgia, D., & Ardito, V. (n.d.). BIOD1ESEL FUEI.ED IDI ENGINES: PERFORMANCES, EMISSIONS AND HEAT RELEASE INVESTIGATION.

Mangra, A. C. (2020). Design and Numerical Analysis of a Micro Gas Turbine Combustion Chamber. Technology & Applied Science Research, 10(6), 6422–6426. www.etasr.com

Nascimento, M. A. R., Lora, E. S., Corrêa, P. S. P., Andrade, R. V., Rendon, M. A., Venturini, O. J., & Ramirez, G. A. S. (2008). Biodiesel fuel in diesel micro-turbine engines: Modelling and experimental evaluation. Energy, 33(2), 233–240. https://doi.org/10.1016/j.energy.2007.07.014

Rabou, L. P. L. M., Grift, J. M., Conradie, R. E., & Fransen, S. (2008). Micro gas turbine operation with biomass producer gas and mixtures of biomass producer gas and natural gas. Energy and Fuels, 22(3), 1944–1948. https://doi.org/10.1021/ef700630z

Sann, E., Anwar, M., Adnan, R., & Idris, M. A. (2013). Biodiesel for Gas Turbine Application — An Atomization Characteristics Study. In Advances in Internal Combustion Engines and Fuel Technologies. InTech. https://doi.org/10.5772/54154

K.A. Al-attab, Z.A. Zainal, Performance of a biomass fueled two-stage micro gas turbine (MGT) systemwith hot air production heat recovery unit, Appl. Therm. Eng. 70 (2014) 61–70.

G. Ofualagba, The modeling and simulation of a microturbine generation system, Int. J. Sci. Eng. Res. 2 (2012) 1–7.

Verhoeff, F.; Rabou, L. P. L. M.; van Paasen, S. V. B.; Emmen, F.; Buwalda, R. A.; Klein Teeselink, H. Proceedings of the 15th European Biomass Conference and Exhibition, Berlin, Germany; 2007; Contribution OA 7.5.

A. Al-Halbouni, A. Giese, M. Flamme, K. Goerner, Applied modelling for bio- and lean gas fired micro gas turbines, Prog. Comput. Fluid Dyn. 6 (2006) 391–405.

R. Calabria, F. Chiariello, P. Massoli, and F. Reale, “Numerical Study of a Micro Gas Turbine Fed by Liquid Fuels: Potentialities and Critical Issues,” Energy Procedia, vol. 81, pp. 1131–1142, Dec. 2015, https://doi.org/10.1016/j.egypro.2015.12.138.

John E. Matsson , An Introduction to ANSYS Fluent 2021 (2021)

L. O. Rodrigues, H. S. Alencar, M. A. R. Nascimento, and O. J. Venturini, “Aerodynamic Analysis Using CFD for Gas Turbine Combustion Chamber,” presented at the ASME 2007 Power Conference, Apr. 2009, https://doi.org/10.1115/POWER2007-22181.

A. H. Lefebvre and D. R. Ballal, Gas Turbine Combustion: Alternative Fuels and Emissions, Third Edition, 3rd Edition. Boca Raton: CRC Press, 2010.

A. H. Lefebvre and V. G. McDonell, Atomization and Sprays, 2nd ed.Boca Raton, FL: CRC Press, 2017.

F. Fuchs, V. Meidinger, N. Neuburger, T. Reiter, M. Zündel, and A. Hupfer, “Challenges in designing very small jet engines – fuel distribution and atomization,” in 16th International Symposium on Transport Phenomena and Dynamics of Rotating Machinery, Honolulu, HAW, Apr. 2016

E. Prasetyo, R. Hermawan, A. L. Putra, and D. L. Zariatin, “Fluid flow analysis of micro gas turbine using computational fluid dynamics (CFD),” in Proceedings of the 4rth IRSTC 2017, 2017

Books:

Bailey, A. E. (2005). Bailey's Industrial Oil and Fat Products, Edible Oil and Fat Products: Processing Technologies. United Kingdom: Wiley.

Websites:

10. Fluids - Ansys Learning Forum | Ansys Innovation Space. (2023). Ansys Learning Forum | Ansys Innovation Space. https://forum.ansys.com/forums/forum/discuss-simulation/fluids/

Solidworks Forum. (2023). SOLIDWORKS Forums. Solidworks.com. https://forum.solidworks.com/

Downloads

Published

2024-06-16

How to Cite

Othman, N. (2024). ANALYSIS OF MICRO GAS TURBINE PERFORMANCE USING MODELLING APPROACH. Jurnal Mekanikal, 47(1), 24–38. https://doi.org/10.11113/jm.v47.473

Issue

Section

Mechanical

Similar Articles

<< < 7 8 9 10 11 12 13 14 15 16 > >> 

You may also start an advanced similarity search for this article.